Glory Info About How To Build Log Bridge

Measure the distance between the outer edges of the timbers and cut a piece of 2″ x 6″ treated lumber to length.

How to build log bridge. Start at one end of the bridge. Part 2 is in the making! Before pouring concrete into the bridge footings, the ford crew installed a grid of rebar that would tie the bridge footings together with the main beam supports.

Build a good base on each side of your waterway. Follow our journey in building a log bridge. First, you’ll need to consider the high water elevation at your proposed timber bridge site.

A tractor or pick… see more An untrussed bridge is simplicity itself. After cutting the floor planks, the next step would be to place the 2 support arched stringers 32 inches apart straight and level.

Attach it to the bottom of the bridge halfway across the span, screwing it to. The bridge ended up being 3 ft wide by 17 1/2 ft long. (mind you, there area few extra touches and tricks of the trade we’ll be telling you about.) the main tools you’ll need are equally basic:

Reinforcement bar next to the bunker log and hammer it into the ground. I stacked a bunch of 5/16” dowels left over. To reduce the length of the bridge, the alignment should be at right angles to the stream and.

Use shovels and hand tools to level areas at the four corners of the bridge for supporting concrete blocks/piers. The left side of the bridge was supported by a log crib that, in turn, supported the 42” logs. In the spring the creek typically overflows it's banks so there will/may be a period where the bridge is under.